Publicidad
Idiomas disponibles
Idiomas disponibles
7.
A safety bolt (A-B-C) is installed in the right panel box, which locks the high recoil speed,
when using a rear-mounted fixture (the safety bolt must be removed if a front-mounted fixture
is used, or else the forward speed is reduced only to a slow speed)
The safety bolt is installed as standard on a new machine.
8.
Place the rotary rudder on the machine and lock the PTO clutch.
9.
The machine is now ready to be used as a rotary milling machine.
Always check that the couplings are sufficiently lubricated. Lubricate with engine oil if necessary,
this will make it easier to attach the accessories.
For the rear-mounted accessory (rotary milling machine), it is important that the safety bolt in
the panel box is always installed to avoid accidents due to high reversing speed.
The safety bolt must be removed when using front-mounted accessories
(sweeper, brush cutter and snow blade).
Switching from rear-mounted to front-mounted accessories
Follow the assembly procedure shown in Figure 8,
Step 1-6:
1. Place the gear in the neutral N position and release the 2 shifter rods from the lock
under the handlebars:
2. PTO shifter (left side when in rear mount position)
3. Shifter (right side when in rear mount position)
4. Remove the left stick from the PTO shifter (A) by removing the spring clip (C). Pull up
the tube (B) from the PTO fork shaft (D) and then rotate the tube 180°.
5. Push down on the handle lock (A) and turn the handle 180°.
6. Replace the PTO shifter rod (A) with the spring clip.
7. A safety bolt (A-B-C) is installed in the right panel box, which locks the high reverse
speed, when using a rear-mounted accessory. It must be removed if a front-mounted attachment
is used, or else the forward speed is reduced to just slow speed.
The safety bolt is installed as standard on a new machine.
8. Place the attachment on the machine and lock the PTO clutch.
The machine is now ready to be used, for example, as a sweeper.
Battery (electric start only)
There is usually no need to charge the battery.
If necessary, refer to Figure 2 and follow the procedure below:
Connect the positive pole to the nut
127
Publicidad
