Publicidad
Idiomas disponibles
Idiomas disponibles
_kCAUTION:
Disconnect
spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
• Clean the underside of your lawn mower
by scraping to remove build-up of grass
and trash.
• Clean engine often to keep trash from
accumulating.
A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• We do not recommend
using a garden
hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water
out. Water in engine can result in short-
ened engine life.
CLEAN
UNDER DRIVE COVER
Clean under drive cover at least twice a
season. Scrape underside of cover with
putty knife or similar tool to remove any
build-up of trash or grass on underside of
drive cover.
,_WARNING:
To avoid serious injury, before performing any service or adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving parts have completely
stopped.
3. Disconnect
spark plug wire from spark plug and place wire where it cannot come in
contact with plug.
LAWN MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST CUTTING
HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear
wheels of your mower, is provided to minimize
the possibility that objects will be thrown out
of the rear of the mower into the operator's
mowing position.
If the deflector
becomes
damaged,
it should be replaced.
DRIVE BELT
If your mower does not operate properly due
to suspected drive belt problems, take your
mower to a Sears or other qualified service
center for repair and/or adjustment.
TO ADJUST
HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to height that
suits you.
1. Remove knob and carriage bolt on one
side of the lower handle.
Hi(
._----'_--
Bolt
.//
J
Handle
bracket
Knob
2. While holding handle assembly, remove
knob and carriage bolt from opposite side,
align hole in handle with desired hole in
handle bracket and reassemble bolt and
knob and tighten securely.
3. Align opposite side of handle with
same positioning hole and secure with
bolt and knob.
ENGINE
Maintenance,
repair, or replacement
of the
emission control devices and systems, which
are being done at the customers
expense,
may be performed by any non-road engine
repair establishment
or individual. Warranty
repairs must be performed by an authorized
engine manufacturer's
service outlet.
ENGINE SPEED
Your engine speed has been factory set. Do
not attempt to increase engine speed or it
may result in personal injury. If you believe
that the engine is running too fast or too
slow, take your lawn mower to a Sears or
other qualified service center for repair and
adjustment.
CARBURETOR
Your carburetor
is not adjustable.
If your
engine does not operate properly due to sus-
pected carburetor problems, take your lawn
mower to a Sears or other qualified service
center for repair and/or adjustment.
IMPORTANT:
Nevertamperwith
the engine
governor, which is factory set for proper en-
gine speed. Overspeeding
the engine above
the factory high speed setting can be danger-
ous. If you think the engine-governed
high
speed needs adjusting, contact a Sears or
other qualified
service center, which has
proper equipment
and experience
to make
any necessary adjustments.
15
Publicidad
