Cleaning And Storage - JOCCA 5893 Manual De Instrucciones

18-E
the button I on the control panel and the device will start
operating.
Select the output speed of air you want, the button
can select three positions:
«I» - low air flow.
«II» - medium air flow.
«III» - maximum air flow.
Press the button to select the desired position.
Button (1). It is used to set the operation time of the device.
When the time is out the device will be automatically
disconnected.
To program it, simply press the button
this button increases the set time a half hour to a total of seven
hours. The lights indicate the scheduled time.
Wind blow mode (4): To select the Wind blow mode of the
device you have to press the key
varies in intensity and direction gradually. If you want the tabs
stay in a certain position, when they are in the desired position,
press the button Wind blow again and the position will be
fixed.
Cold mode: button (3). To get cooler and humid air place ice
in the largest compartment located at the top of the device (e)
or into the lateral water containers (f) and press
light on it also purifies the air, if the light is off, only cool dry air
is coming out.
Function Mode (6): to select the type of wind blow you have
to press the button . There are three types of wind blowing:
sleep mode, natural and normal. Select the desired one.
Remote control: controls the same functions of the device on the
distance of 5 meters.
Unplug the device when you finished using it.

CLEANING AND STORAGE

-Before cleaning the fridge, make sure the device is not plugged
in the current and the water/ice tank is empty.
- To empty the water tank in case of excess of the water or to
clean the device, open the drain plug in the lower back part,
(5). You
. Each time you press
. With this function the air
. With the
to remove it turn the plug counter clockwise until it is separated
from the device, pull the rubber stopper and drain the water.
Once all the water is out, place the rubber stopper and drain
plug again.
-Please clean the water tank from time to time.
-The filter should be cleaned with a damp cloth approximately
every 15 days.
Steps to be taken to change the filter:
1.- Take the grid out of the filter with the help of a screwdriver.
2.- Take the filter out of its deposit and shake well to clean.
3.- If the filter is too dirty, put it in a bowl with water and neutral
soap.
4.- Put the clean filter, carefully, inside the deposit.
NOTE: Filters usually last 1 year, in case any accident with it,
change it immediately.
Disconnect the appliance from the mains supply if it is not going
to be used for some time.
TECHNICAL SPECIFICATIONS
220-240V ~ 50/60Hz 60W
This device conforms to the safety requirements and provisions of
directives 2006/95/CE on Low tension devices and 2004/108/CE
on Electromagnetic Compatibility.
PROTECTION OF THE ENVIROMENT – DIRECTIVE
2002/96/EC
This product has been designed and manufactured with high
quality materials and components that can be recycled and
reused.
When you see the symbol of a crossed out litter bin on
wheels next to a product, this means that the product
conforms to the European Directive 2002/96/EC.
Please obtain information about the local recycling
system for electric and electronic products.
Follow the local rules and do not dispose of used products by
throwing them in the normal bins at home. Proper recycling
of your used product will help avoid negative impacts on the
environment and people's health.
E-19