Tramontina 42360/210 Manual De Instrucciones página 19

Instruction Manual
e) Before powering on the drill, make sure the bit is
not touching other objects. When the drill is on, never
touch the bit, even when wearing protective gloves.
f) Do not touch the bit after drilling, since it can be hot
at high temperatures, injuring the operator's hands.
Instructions for Drill Operation
1. Fastening the bits to the drill:
– Loosen the chuck with the help of the chuck key
provided with the drill, then open it with your hands
turning the outer ring;
– Insert the bit between the chuck inner jaws and firmly
tighten with the chuck key. Always tighten using the
three holes for better fastening in order to prevent the
bit from slipping.
42360 - 1/2" 500 W Impact Drill
2. Using the trigger and lock button:
– After connecting the plug to an outlet, press the trigger
to start operation;
– To make operation easier and to avoid user fatigue
during long continuous work, you can use the lock button.
After pressing the trigger, press the lock button to keep
the tool running without the need to keep pressing the
trigger. Press the trigger again to release it.
Lock button for
continuous work
WARNING: before installing or removing any accessory
to or from drill chuck, make sure the trigger is not
pressed and the power plug is disconnected from the
power grid.
3. Chuck rotation direction:
– By reversing the switch on the top part of the trigger,
you can select clockwise or counterclockwise rotation for
the chuck.
WARNING: only reverse the tool's rotation direction
when it is stopped.
19