Tramontina 42360/210 Manual De Instrucciones página 20

4. Auxiliary handle fixation:
– Always use the auxiliary handle for safe operation and
keeping the tool stable during its use;
– Fit the auxiliary handle through the chuck until it
reaches the plastic part where it will be fastened. Then
turn the grip clockwise until the handle is firmly fastened;
– For greater operator comfort and tool stability during
operation, the auxiliary handle can be set at 360°.
5. Use of accessory for determining drilling depth:
– Fit the bit to the chuck;
– Loosen the accessory by turning the auxiliary handle
counterclockwise;
– Set the accessory according to the desired drilling
depth;
– Tighten the auxiliary handle clockwise to firmly fasten
the depth setting accessory on the side of the auxiliary
handle.
Acessório de
Depth measuring
Medição de
accessory
profundidade
20
6. Selecting the operation (drilling/hammer drilling):
– When working with plastic, wood, and steel, use the
"drilling" option by pressing the switch with a bit drawing
on the right side of the tool;
– When working with concrete and masonry, in order to
increase tool efficiency, use the "hammer drilling" option
by pressing the switch with a hammer drawing on the left
side of the tool.
360°
7. Tips for using drills:
– If the tool becomes too hot, operate it without any
load for a few minutes to cool down the motor and the
equipment housing;
– Avoid working for a long time at low speeds;
– Always ensure that the accessory used in the chuck is
firmly in place to avoid potential accidents;
– When the work is done, let the tool run without any load
for a short period of time in order to loosen any dust and
dirt stuck to the bit and tool.
NOTE: the pictures are for illustrative purposes only,
always wear personal protective equipment (PPE)
while working with electric tools, such as leather
gloves, faces masks for protection against dust and
soot, anti-slip safety shoes, hard hat, earplugs, and
safety goggles.
Instruction Manual
Hammer drilling
42360 - 1/2" 500 W Impact Drill