Publicidad
Idiomas disponibles
Idiomas disponibles
• DO NOT use hazardous chemicals to clean or come into
contact with the unit. To prevent damage to the surface
finish, use only a soft cloth to clean the appliance.
DO NOT use solvents, or strong detergents.
• DO NOT use the unit in the presence of flammable
substances or vapors such as alcohol, insecticides,
or gasoline.
• If the appliance is making unusual sounds or is emitting
smoke or an unusual odor, unplug it immediately.
• DO NOT clean the unit with water. Water can enter
the unit and damage the insulation, creating a shock
hazard. If water enters the unit, unplug it immediately
and contact Global Industrial Customer Service at
1-800-645-2986.
• Utilize two or more people to lift and install the unit.
• Be sure all accessories are removed from the packaging
before installation and use.
• Avoid contact with the metal parts of the appliance
when removing or re-installing the filter.
• DO NOT block the air inlet or outlet of the dehumidifier.
Reduced air flow will result in poor performance and
could damage the unit.
• ALWAYS grasp the plug when plugging or unplugging
the unit. Unplugging the unit by pulling on the cord can
run the risk of electrical shock and damage.
• Install the dehumidifier on a sturdy, level surface
capable of supporting up to 110 lbs. (50kg). Installation
on a weak or non level surface can result in the risk of
property damage and personal injury.
• Close all doors and windows to the room for
efficient operation.
CAN ICES-3 (B)/NMB-3(B)
FCC CAUTION:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
IMPORTANT - GROUNDING METHOD
This product is factory equipped with a power supply
cord that has a three-pronged grounded plug. It must
be plugged into a mating grounding type receptacle
in accordance with the National Electrical Code and
applicable local codes and ordinances. If the circuit
does not have a grounding type receptacle, it is
the responsibility and obligation of the customer to
exchange the existing receptacle in accordance with the
National Electrical Code and applicable local codes and
ordinances. The third ground prong should not, under
Energy Efficient Portable
Dehumidifier
2
any circumstances, be cut or removed. Never use the
cord, the plug or the appliance when they show any sign
of damage. Do not use your appliance with an extension
cord unless it has been checked and tested by a qualified
electrical supplier. Improper connection of the grounding
plug can result in risk of fire, electric shock and/or injury
to persons associated with the appliance. Check with
a qualified service representative if in doubt that the
appliance is properly grounded.
ELECTRICAL CONNECTIONS
Before plugging the appliance into outlet check that:
• The power supply corresponds to the value indicated
on the rating plate on the back of the dehumidifier.
• The power outlet and electrical circuit are adequate for
the dehumidifier.
• The outlet matches the plug. If this is not the case, have
the plug replaced.
• The outlet is adequately grounded. Failure to follow
these important safety instructions may result in injury or
damage and exempts Global Industrial of all liability.
Check local regulations for proper
waste disposal procedures. As a
reminder of the need to dispose of
household appliances separately,
the product is marked with a
crossed-out wheeled dustbin.
NOTES ON HUMIDITY
Air always contains a certain amount of water in the
form of vapor. This determines the level of humidity in an
atmosphere. The capacity of the air to hold water vapor
increases with temperature. This is why in our homes, as
soon as the temperature decreases, the vapor contained in
the air condenses. This is evident on the colder surfaces in
the room, such as the windows, walls, etc. The purpose of a
dehumidifier is to remove the excess moisture from the air,
avoiding damage caused by condensation.
Experts have established that the optimum environmental
conditions for our well-being and for the home are
between 40% and 60% relative humidity. In low
temperatures, it is recommended to heat the room
minimally. This considerably increases the dehumidifying
power of the appliance. With heating, the condensation
formed by the water vapor on windows and other cold
surfaces evaporates into the air to be collected by the
dehumidifier. Air leaving the dehumidifier is usually about
1-2° warmer than room temperature.
User's Manual
Publicidad
