IKRA ICC 2/2035 Instrucciones De Manejo página 44

EN ENGLISH
OPERATION
Adding the chain lubricating oil
WARNING
Never work without chain lubricant. If the saw
chain is running without lubricant, the guide bar
and the saw chain can be damaged. It is essential to
frequently check the oil level in the oil level gauge
and before starting to use the chain saw.
Keep the reservoir more than ¼ full to ensure sufficient oil
is available for the job.
Note: It is recommended to use a vegetable based chain
oil when pruning trees. Mineral oil may harm trees. Never
use waste oil automotive oil, or very thick oils. These
could damage the chain saw. Clear surface around the oil
cap to prevent contamination.
Holding the chain saw
Always hold the chain saw with your right hand on the
rear handle and your left hand on the front handle. Grip
both handles with the thumbs and fingers encircling the
handles.
TRANSPORTATION AND STORAGE
Always lightly oil the chain when storing to prevent rust. Always empty the oil tank when storing to prevent leakage.
Stop the machine, remove the battery, and allow it to cool before storing or transporting.
Clean all foreign materials from the machine. Store the machine in a cool, dry, and well-ventilated place that is
inaccessible to children. Keep away from corrosive agents, such as garden chemicals and de-icing salts. Do not store
outdoors.
Fit the guide bar cover before storing the machine or during transportation.
For transportation in vehicles, secure the machine against movement or falling to prevent injury to persons or damage
to the machine.
CAUTION
Hearing damage
A longer stay in the immediate vicinity of the
running unit may cause hearing damage. Wear ear
protectors.
When working with the device, a certain level of noise
cannot be avoided. Noisy work should be scheduled
for hours, during which it is allowed by statute or other
local regulations. Adhere to any applicable rest times
and limit your working time to the necessary minimum
time. For your personal protection and the protection
of people nearby, suitable hearing protection must be
worn.
42
Starting the chain saw
Before starting the chain saw, you should install the
battery pack in the chain saw and make sure the chain
brake is in run position by pulling the chain brake lever/
hand guard toward the front handle.
Checking and operating the chain
brake
Activate the chain brake by holding the front handle
with your left hand. Press the chain brake lever/hand
protection towards the guide rail with the back of your
hand, while the chain is moving fast. Please ensure that
both your hands are on the handles at all times.
Reset the chain brake back into the run position by
grasping the top of the chain brake lever/hand guard and
pulling toward the front handle until you hear a click.
WARNING
If the chain brake does not stop the chain
immediately, or if the chain brake will not stay in
the run position without assistance, bring the chain
saw to an service station for repair prior to use.
Please observe the following: according to the German
Machine Noise Protection Regulation from September
2002, this device may not be operated on Sundays
and Bank holidays or working days from 8pm to 7am.
Furthermore, it is forbidden to operate the machine at the
following times of day: from 7 a.m. to 9 a.m., from 1 p.m.
to 3 p.m. and from 5 p.m. to 8 p.m.
Please do also consider any local regulations concerning
noise protection!
DANGER
Warning This power tool generates an
electromagnetic field during operation. Under
certain circumstances, this field may affect active
or passive medical implants. To reduce the risk
of serious or fatal injury, we recommend that
individuals with medical implants consult their
physician and the manufacturer of the medical
implant before operating the machine.