WATSEA POWER800 Manual Del Usuario página 8

➔ Pipe installation :
A. Assemble the water inlet tube to the strainer, attach it to the aquarium with the suction cups.
B. Assemble the drain tube to the waste tube with the connector, then hang it on the aquarium and secure
the waste tube with the suction cups.
C. Assemble the water inlet tube to the water inlet hose and do the same with the drain tube and its hose.
A B C
Filter start-up :
For the POWER 800 filter :
Press the button continuously to release the air and allow the water to enter the filter.
Stop pressing the button when the water in the hose is at the same level as the water
in the aquarium:
For POWER 1200/1800 filters :
Connect the priming bulb to the water suction pipe, press the blue part of the bulb several times to expel the
air from the filter and fill it with water. Once the filter is filled, remove the bulb and check that the outlet pipe is
connected to the reject tube:
Plug in the filter to start it.
Check if the filter is working properly within one hour.
If the filter is working properly, the water will come out of the
discharge tube :
7