AERMEC ANKI Manual De Uso página 19

4 READINGS MENU
To access the menu from the main template using the arrow keys
N. Code
L00 tuA
L01 tiA
L02 tsb
L03 tGP
L04 tAE
L05 HP
L06 BP
L07 tEr
L08 SAb
L09 CP
L10 HC0
L11 SP0
L12 rEL
L13 Set
L14 dCP
L15 dCP
L16 Po
L17 Cor
L18 Uo
L19 UoB
L20 HSt
L21 dFo
L22 dHt
L23 ASP
L24 MF In
Summary of the configurator code set on the machine:
Language selection template:
, scroll down or up to reach the screen shown below:
Name
Water Outlet Temperature
Water Inlet Temperature
Coil temperature
Discharge refrigerant temperature
External air temperature
Delivery pressure
Suction pressure
Thermostat
Safety band on force-off
CP times
Operating hours
Pick-ups
Release
Current setpoint
DCP setpoint
DCP band
Power fraction
Inverter Current
Inverter outlet voltage
Bus voltage
Inverter dissipater temperature
Value of the dynamic Force-Off
DHW remote probe value
Compressor intake probe value
Multi-function input value
Output temperature (in °C) from the water consumption read by the SUW NTC 10k probe
Input temperature (in °C) to the water consumption read by the SIW NTC 10k probe
Input temperature (in °C) read by the SS NTC 10k probe in the condensation battery
Temperature (in °C) read by the SGP probe on force gas
Temperature (in °C) read by the SAE NTC 10k probe
Bar pressure read by the compressor delivery transducer
Bar pressure read by the compressor pressure suction transducer
It displays the percentage of power required by the thermostat on the basis of the
proportional/integral algorithm
Low water con tent control algorithm. This parameter indicates the temperature threshold
for re-starting the compressor
Compressor times. This display shows the time to the start or to the stop of the compressor
This screen shows the hours of operation for the compressor
This display shows the number of pick-ups carried out by the compressor
This display shows the software version
It displays the setpoint used when the machine is operating: it includes the possible
corrections of the room temperature (if this function is active)
Pressure setpoint used for condensation control
Pressure differential used when checking the condensation
Power fraction: this reading shows how much power is currently supplied to the machine
Current (in A) measured from the inverter module
Output voltage (in V) measured from the inverter module
BUS voltage (in V) measured from the inverter module
Heat dissipator temperature (in C°) of the inverter module
Current dynamic Force-Off value calculated on the basis of the outdoor air temperature
Value read by the remote probe, located in the water accumulation of the system
Temperature read by the compressor suction probe
Temperature or Volts, depending on the configuration of the multi-function input
(parameter N11)
Meaning
19