Publicidad
Idiomas disponibles
Idiomas disponibles
ADVANCING THE CUTTING LINE
Line advance is controlled by tapping the string head on
grass while running motor at full speed.
„ Run with the switch trigger fully pressed.
„ Tap the bump knob on ground to advance line. The line
advances each time the knob is tapped. Do not hold the
knob on the ground.
NOTE: The line trimming cut-off blade on the grass
deflector will cut the line to the correct length.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off motor or disconnect from power supply, and
wait for all moving parts to stop. Failure to follow these
instructions can result in serious personal injury or prop-
erty damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
NOTE: If the line is worn too short you may not be able to
advance the line by tapping it on the ground. If so, STOP
THE MOTOR, remove the battery pack for cordless power
heads, or disconnect the plug from the power source for
electric power heads, and manually advance the line.
To advance the cutting line manually:
„ Stop the motor, remove the battery pack for cordless
power heads, or disconnect the plug from the power
source for electric power heads.
„ Push the bump knob in while pulling on line(s) to manually
advance the line.
MAINTENANCE
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal injury.
LINE REPLACEMENT
See Figures 8 - 9.
Use original manufacturer's replacement line for best
performance.
„ Stop the motor, remove the battery pack for cordless
power heads, or disconnect the plug from the power
source for electric power heads.
„ Rotate the bump knob clockwise as necessary to align
the arrows on the bump knob with the arrows on the
string head housing.
„ Use one piece of pre-cut trimmer line, or cut one piece
of bulk trimmer line 10-16 ft. long.
„ Insert the line into the eyelet on the string head housing.
Push until the end of the line comes out the other side
of the housing. Pull the line until equal amounts of line
appear on both sides of the housing.
NOTE: Line may jam if more than 16 ft. is loaded.
„ Either by hand or using the SPEED WINDER™, rotate
the bump knob clockwise to wind the line on the spool
until approximately 6 in. of line is showing on each side.
NOTE: For best results, after every five to seven revolutions
of the SPEED WINDER™, pull both line ends taut for best
loading results and to help prevent line from tangling.
„ Push the bump knob down while pulling on line(s) to
manually advance the line.
8 — English
Publicidad
