Publicidad
Idiomas disponibles
Idiomas disponibles
Notes:
- You don't need to reset the programmes in P mode because the
appliance remembers your previous settings.
- If the appliance was in standby mode before the power cut, it will
remain in standby mode when the power is restored.
12. Resetting the thermostat
It is possible to cancel all programming and return to the factory set-
tings. To do this, follow the below procedure:
- Press
and + at the same time for 2 seconds. The appliance will
emit 3 beeps to indicate that it has been reset to its original settings.
Anti-overheating safety device
Your radiator is fitted with a safe-
ty device that switches it off if it
overheats. If the radiator stops
working, switch it off and inspect
the air inlet and outlet (if pres-
ent) to check that they're not
blocked. Wait at least 30 min-
Rev 0_28 11 23
utes for the protection system to
reset before restarting the heat-
er. If the heater does not work,
or if the safety device switches it
off again, take it to your nearest
service centre for inspection or
repair.
Made in China
Page 50
Publicidad
