Publicidad
Idiomas disponibles
Idiomas disponibles
The radiators are fitted with an advanced control system with touchscreen commands, and indi-
cator lights that indicate the function set.
Changes in the settings are also highlighted by an acoustic signal.
• When the radiator is connected to the power supply, all the LEDs light up for 2 seconds and a
long beep is heard, after which L1 and L8 remain on.
• If you want to heat the room at low temperature, touch T2. Green LEDs L2 and L7 switch on,
and you hear a beep. When the surface of the radiator reaches the temperature set, L7 switch-
es off, and then switches on and off as it maintains the temperature set.
• If you want to heat the room at medium temperature, touch T3. Green LEDs L3 and L7 switch
on, and you hear a beep. When the surface of the radiator reaches the temperature set, L7
switches off, and then switches on and off as it maintains the temperature required.
• If you want to heat the room at maximum temperature, touch T4. The green L7 LED switches
on, and you hear a beep. When the surface of the radiator reaches the temperature set, L7
switches off, and then switches on and off as it maintains the temperature required.
• If you want to maintain maximum surface temperature for a limited period of 2 hours, touch T5.
LEDs L5 and L7 switch on. The radiator will work at maximum temperature for 2 hours, after
which it will return to the function set prior to the Boost function.
• If you wish to lock the keyboard after completing the settings, hold the T6 key down for 5 sec-
onds, until you hear 4 beeps to confirm this setting. If you pass your hand over the other keys,
LED 6 will flash for 2-3 seconds to indicate that the keyboard is locked.
Only key T1 still works, to put the radiator in stand-by mode at any time.
To unlock the keyboard again, hold key T6 down for 5 seconds, until you hear 4 consecutive beeps
to confirm that it is unlocked.
Remote control
Key
Key
CLOCK
Key
MODE
Key
TIMER 2h
[ 27 - EN ]
Display
Key
Key
STAND-BY
Key
Publicidad
