AENO DI1 Guia De Inicio Rapido página 13

7. Point the outlet of the nozzle into the oral cavity and turn on the device by
pressing the power button again.
8. Perform oral hygiene by moving the outlet of the nozzle along the gum
contour as shown in Figure E.
Note. If the tank runs out of water during operation, turn off the device by
pressing the power button once and refill the tank as described in items 1 and
2 above. Then continue with your oral hygiene.
9. Turn off the device by pressing the power button once.
10. Open the tank cap and drain the remaining water.
11. Clean the nozzle and tank (see "Daily Care").
Cleaning and Maintenance
Daily Care. Press and hold the nozzle release button and pull the nozzle
upwards. Detach the tank as shown in Figure D. Rinse the nozzle and tank
under running water, then dry them thoroughly. Reinstall the tank and nozzle.
Total Care. Perform the total cleaning of the water tank once a week. Detach
the tank as shown in Figure D. Wash it outside and inside under running water
with a soft brush or sponge, without detergents or cleaning agents, and dry
thoroughly. Reinstall the tank.
Troubleshooting
1. The device does not turn on. Possible cause: the battery is low. Solution:
charge the device (charging time – at least 4.5 hours).
2. The device does not supply water. Possible causes: the tank is out of water;
the outlet of the nozzle is clogged. Solution: fill the tank with water; clean
the outlet of the nozzle.
3. Insufficient water supply. Possible cause: the wrong operating mode /
strength has been selected. Solution: set the required operating mode /
strength with the mode and strength selection button.
ATTENTION! If none of the suggested methods have solved the problem,
contact your supplier or an authorized service center. Do not disassemble the
device or attempt to repair it yourself.
aeno.com/documents 13