Publicidad
Idiomas disponibles
Idiomas disponibles
BIT STORAGE
See Figure 9.
When not in use, bits provided with your drill can be
placed in the storage area located on the bottom of your
drill as shown in Figure 9.
SCREWDRIVER
BITS
DRILLING
See Figure 1 I.
BIT
STORAGEAREA
Fig. 9
,_
WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
LEVEL
See Figure 10.
A convenient feature provided with your drill is a level. It
is recessed in the motor housing on back of your drill. It
can be used to keep drill bit level during drilling opera-
tions.
REARVIEWOF DRILL
LEVEL
Fig. 10
Fig. 11
When drilling hard smooth surfaces use a center punch to
mark desired hole location. This will prevent the drill bit
from slipping off center as the hole is started. However,
the low speed feature allows starting holes without center
punching if desired. To accomplish this, simply operate
your drill at a low speed until the hole is started.
The material to be drilled should be secured in a vise or
with clamps to keep it from turning as the drill bit rotates.
Hold tool firmly and place the bit at the point to be drilled.
Depress the switch trigger to start tool.
Move the drill bit into the workpiece applying only enough
pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
,_
WARNING:
Be prepared for binding or bit
breakthrough.
When these situations occur, drill has
a tendency to grab and kick opposite to the direction
of rotation and could cause loss of control when
breaking through material. If not prepared, this loss
of control can result in possible serious injury.
When drilling metals, use a light oil on the drill bit to keep
it from overheating. The oil will prolong the life of the bit
and increase the drilling action.
if the bit jams in workpiece or if the drill stalls, release
switch trigger immediately. Remove the bit from the
workpiece and determine the reason for jamming.
13
Publicidad
