Descargar Imprimir esta página

Furius FIRE 1320 Manual De Usuario página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Power source
Make sure that the power source to be used conforms to the power requirements specified on the demolition nameplate.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power receptacle while the power switch is
in ON position, the demolition hammer will start operation immediately, which can cause serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The
extension cord should be kept as short as practicable.
Operation
1. Switch action
Switch on
Press the switch towards
Switch off
Release the switch towards
If continuous Operation, turn on the switch and then push in The lock
button, to stop from the locked Position, just press the switch fully, then
release it.
2. Operate this demolition hammer using additional pressure. Performance will be better if properly pressed against the work
surface.
Note:
Sometimes the power tool does not begin the striking the stroke even the motor keep running, because oil inside become
thick. If the power tool is used at a low temperature, or it is used after a long idle time, this demolition hammer should be kept
running for above 5 minutes to warm up.
direction
direction
6
Switch
YEAR
WARRANTY

Publicidad

loading

Este manual también es adecuado para:

Fdh1320