Publicidad
Idiomas disponibles
Idiomas disponibles
[] Channel
Selection
Select channels by using[CHA/V]
or [the Numberbuttons].
• To select the memorized
channels,
use [CH A/V]
or
[the Number
buttons].
• To select the non-memorized
channels,
use
[the Number
buttons].
To Use [the Number buttons]
[]Volume
Adjustment
Thissection describes h owto adjustthevolume. T hemutefunction, w hich
turnsthesoundoff andon, isalsodescribed.
Use [VOL. LIT]
to adjust the audio volume.
- When selecting
analog channel
12
When selecting
digital
channel
12-1
Be sure to press [-] before entering
the minor
channel
number.
• Press [CH RETURN] to return to the previously
viewed channel.
About
digital
TV broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality.
Not all digital TV broadcasts
are high
definition
(HD). To confirm
whether
your watching
TV
program
is in HD, refer to the program
guide, contact
your cable/satellite
provider
or local TV stations.
NTSC
_
ATSC
(analog
mode)
(digital
mode)
]8:oo
8:3o
:1
19:oo
iiii
i_, _
.............................. 19:30
2o:oo
<_
can be changed
by using [CH A IV].
What is the minor
channel?
By using high compression
technology,
digital
broadcasting
offers a service that enables
multiple
signals to send simultaneously.
Therefore,
you can select more than one program
per
major channel
since digital
broadcasting
technology
distinguishes
between
multiple
channels
broadcast
by
single network.
Note:
• "No Signal'willappearon
the TVscreen after the minor
channel broadcast is over.
• "Audio onlyprogram" message will appear on the TV
screen, when you receiveonly sound signal
• The volume
bar will be displayed
atthe
bottom
of
the TV screen when adjusting
the volume.
• The volume
bar will automatically
disappear
in a few
seconds.
Press [MUTE D_] to turn offand
on the sound.
• "Mute"
is displayed
on the TV screen for a few
seconds.
Press [MUTE D_] again or [VOL• _/_]
to recover the
original
volume.
[] Sleep Timer
Thesleeptimer canbeset toautomatically turnoff theunit after an
incremental p eriodoftime.
Press [SLEEP] to set the sleep timer.
• Sleep timer display appears
on the TV screen.
2
Press [SLEEP] repeatedly
to change the amount
of time
until shut off.
• You can setyour
unit to turn offafter
a set period
of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After setup, the sleep timer display can be called up
for checking
by pressing [SLEEP].
To cancel the sleep timer
Press [SLEEP] repeatedly
until "Sleep Off" is displayed
on the TV screen.
Note:
• The sleep timer display will automatically disappear in a
few seconds.
• Whenyoudisconnecttheunitfrom
theACoutletorwhen
a power failure occurs, the sleep timer setting will be
canceled.
EN
Publicidad
