Publicidad
Idiomas disponibles
Idiomas disponibles
[] Supplied
Accessories
owner's
manual
quick start guide
(1EMN23740)
(1EMN23820)
remote control
batteries
Phillips pan screw for
(NF015UD)
(AA x 2)
attaching
the stand x 3
(FPH34100)
• If you need to replace these accessories, please refer to the part No. with the illustrations
and call our toll free
customer
support
line found on the cover of this manual.
• Depending
on your antenna
system, you may need different
types of combiners
(mixers) or separators
(splitters).
Contact your local electronics
store for these items.
[] Attaching
the
Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
Insert the stand all the way to the
main unit slowly until it clicks.
Make sure not to put the AC power
cord between
the stand and the
unit.
Drive Phillips pan screws in the 3
threaded
holes at the bottom
of the
stand with a screwdriver
tightly.
To remove
the stand from
this unit
Unscrew the Phillips pan screws indicated by"_Y', then lift the lever on the bottom
stand and remove the stand from the unit slowly. Be careful not to drop the stand
when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well asdamage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
[] Symbols
Used
in this Manual
The following
is the description
for the symbols used in this manual.
Description
refers to:
: Digital TV operation
: Analog TV operation
• If neither
symbol appears under the function
heading, operation
is applicable
to both.
EN
Publicidad
