ERRECOM Jet Gun Pro Manual De Uso página 8

Be aware of the weight of the device during storage. Place the appliance on a level surface. Store it in a safe place;
keep it away from children. Store the product indoor to prevent the water in the unit from expanding under freezing
conditions and to protect the device from frost. Temperature storage: between 10°C and 30°C. Store the product in the
original package or cover it with a suitable cloth to protect it against dust.
CAUTION - Danger of injury from electric shock
Switch off the device and unplug the charger from the device before performing any work on the appliance.
Clean the valve opener and fine filter regularly. Do not damage them.
1. Remove the valve opener
and fine filter.
Turn off the device and unplug the charger from the device before performing any maintenance work. Repair work and
work on the electrical components may be performed by the authorized customer service only. You can remedy yourself
for minor malfunctions, using the following overview. When in doubt, please consult the authorized customer service.
PROBLEM
Device not running
Fluctuating pressure
Device pulsation
Water does not come out
of the nozzle
8
STORAGE
CARE AND MAINTENANCE
CLEAN THE VALVE OPENER/FINE FILTER
fine filter
2. Clean the valve opener and
fine filter under running water.
TROUBLESHOOTING GUIDE
CAUSE
Flat battery
Low battery
Valves dirty, worn out or stuck
Required pressure is impossible
to reach
Air in inlet hose
Inadequate supply of mains water
Partially blocked nozzle
Blocked water filter
Twisted hose
No water supply
Water filter blocked
Nozzle blocked
3. Reinsert the fine filter and valve
opener making sure to fit the groove.
SOLUTION
1. Charge the battery and wait for the green
light. 2. Switch on the device to make sure
it starts.
1. Check that hoses and connections are
airtight. 2. Clean the valve opener and fine filter.
3. Make sure that the valve opener is inserted
with the pin pointing upwards
1. Allow machine to run with open trigger until
regular working pressure resumes.
2. Clean the nozzle removing contamination
and debris 3. Make sure there is enough water
in the tank. 4. Check that the water
supply corresponds to specifications required.
1. Clean the filter 2. Clean the nozzle