Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING PRESET FILTER
CYCLES
Filter duration is programmable between 0.5
and 6 hours in 30 minute increments (0.5
hours) for both filter cycles. To program the
cycle times:
1. Press and hold Light button for 5
seconds until F1 is displayed.
2. Press the Plus or Minus button to
adjust the cycle time for F1.
3. Press the Light button to store the F1
cycle and move to the F2 cycle.
4. Press the Plus or Minus button to
adjust the cycle time for F2.
5. Wait 15 seconds to allow the exit timer
to expire and store the setting.
IMPORTANT: To reset the first filter cycle
start time, skip step 5 and continue pressing
the Light button until the actual temperature
is displayed. Powering down of the spa will
also reset the first filter start time.
FILTER CYCLE SUSPENSION:
filter cycle will be suspended every time a jet
pump or light is activated manually during the
filter cycle time. The suspension will end 10
minutes after the completion of the manual use.
OPERATIONAL MODES
The Standard Mode is the default operational
mode preset from the factory. In order to program
the spa to operate in the Economy mode you must
enter the programming mode to make the change.
Water sampling will turn the jet pump on and
circulate the water for up to a couple of minutes.
STANDARD MODE:
to maintain the desired temperature with
periodic water circulation (sampling) to
sample and heat the water to the set
temperature.
NOTE: Freeze Protection (Smart Winter
Mode
) will assert as necessary during all
modes when cold temperatures activate this
mode. This mode is automatic and can not be
changed.
CONTROL PANEL OPERATION
The
Is programmed
The Following Three Modes are only used on
single pump models.
ECONOMY MODE:
Water sampling only done during the filter cycle.
SLEEP MODE:
the filter cycles. Water sampling only done during the
filter cycle.
QUIET MODE:
running (water sampling) after the F2 filter cycle
is complete for up to 11.5 hours. You can set this
mode between 0.5 hours and 11.5 hours in half
hour increments.
To enter the programming screen and toggle
between Standard, Economy, Sleep and
Quiet Modes the following is required:
1. Press and hold the Light button for 5
seconds
2. Press the Light button several times
until St, Ec, SL, or nt is displayed.
3. Use the Plus or Minus button to
choose between the Modes.
St = Standard Mode, Ec = Economy
Mode, SL Sleep = Mode and nt =
Quiet Mode.
4. Wait 15 seconds to allow the exit timer
to expire and store the setting.
To Program the Quiet Mode the following is
required:
Once in the nt mode, press the Light button then
press the Up/Down button to change the amount
of time you do not want the jet pump to come on
between F2 and F1.
OFF MODE:
This mode allows you to stop
all spa functions for 30 minutes to perform
quick spa maintenance. To place the spa
in OFF MODE, press and hold the Jets
button for 5 seconds. The display will toggle
between OFF and water temperature when
in the OFF MODE. To stop the OFF MODE
before the 30 minute cycle time is complete,
simply tap (short press) the Jet button.
ECONOMY MODE for 2 pump models
only:
This mode allows you to lower the
12
The spa will not heat.
The spa will only heat during
Keeps the jet pump from
Publicidad
