Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 13 Monday, February 19, 2024 1:21 PM
• After cleaning and washing the burner heads
and caps, wipe and dry them carefully. Make
sure that the flame holes are clean and
completely dry.
• Wipe the fixed parts of the burner cup with a
damp cloth and dry afterwards.
• Gently wipe the ignition device and flame
supervision device with a well wrung-out cloth
and wipe dry with a clean cloth.
• Do not attempt to remove the ignition device
from the cooktop or burner bases.
• Before placing the burners back on the cooktop
surface, make sure that the injector is not
blocked.
Reassemble the Auxiliary, Semi-Rapid,
Rapid and Triple-Crown Burners as follows:
1
Place the flame spreader
e
cup
so that the ignition device and the
flame supervision device extend through their
respective holes in the flame spreader. The
flame spreader must click into place correctly.
2
Position the burner caps (
d
flame speader
so that the retaining pins fit
into their respective recesses.
CAUTION
• Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
d
onto the burner
a
b
c
,
,
) onto the
- The locating pins must fit exactly into the
notches.
MAINTENANCE
13
Publicidad
