WolfPack KWAG1801 Manual De Instrucciones página 33

• If the cutting disc jams, or if you stop working, turn the device off and hold it until the disc
stops moving completely. Never try to pull a still-rotating cutting disc out of the cut, as this
may result in a machine kickback. Determine and correct the cause for the machine
becoming jammed.
• Never turn the device back on while it is inside the workpiece. Allow the cutting disc to
reach its full rotational speed before you begin your cut. Otherwise the disc may become
caught, jump out of the workpiece or cause a kickback.
• Support slabs or large workpieces to avoid the risk of kickback resulting from a jammed
cutting disc. Large workpieces can bend under their own weight. The workpiece must be
supported on both sides of the disc; in the area of the cut as well as on the edge.
• Exercise special care when doing "plunge cuts" into existing walls or other areas that are
not visible. In such cuts, the cutting disc may cut into gas or water pipes, electrical lines or
other objects and cause a machine kickback
7. ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND CHARGERS
7.1 BATTERIES
• Never attempt to open these for any reason.
• Do not store in locations where the temperature may exceed 40°C.
• Charge only at ambient temperatures between 4 °C and 40 °C.
• Store your batteries in a cool dry place (5 °C-20 °C). Never store batteries in discharged
condition.
• It is better for Li-ion batteries to discharge and reload them regularly (at least 4 times a
year). The ideal charge for long-term storage of your Li-ion battery is 40% of capacity.
• When disposing of batteries, follow the instructions given in the section "Protecting the
environment".
• Do not cause short circuits. If a connection is made between the positive (+) and negative
(-) terminal directly, or via accidental contact with metallic objects, the battery is short-
circuited and an intense current will flow, causing heat generation which may lead to
casing rupture or fire.
• Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged, resulting in electrolyte leakage and/or
internal short-circuiting leading to heat generation causing rupture or fire. Moreover, do
not dispose of the batteries in fire, as an explosion and/or intense burning may result..
• Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
a) Carefully wipe the liquid off using a cloth. Avoid skin contactl.
b) In the event of skin or eye contact, immediately rinse with water. Neutralise with a
mild acid such as lemon juice or vinegar
c) In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
33