Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
z When clearing deeper drifts, hold the electric snow shovel
by the upper and lower handles and use a swinging or
sweeping motion. Remove up to 6 in. (15 cm) of snow
with each pass and repeat as many times as needed.
z Keep the cord clear of obstructions, sharp objects and
the rotating paddles. Do not pull sharply on the cord or
abuse it in any manner. Frequently inspect the cord for
signs of damage. If damage is found, replace the cord
immediately.
z This electric snow shovel is equipped with a 1 W LED
light to faciliate clearing at night and under conditions of
MAINTENANCE
WARNING
servicing the unit, stop the motor, wait for all moving
parts to stop, and disconnect from power supply. Fail-
ure to follow these instructions can result in serious
personal injury or property damage.
WARNING
side shields marked to comply with ANSI Z87.1. Fail-
ure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING
rized replacement parts. Use of any other parts can
create a hazard or cause product damage.
NOTICE
Periodically inspect the entire product
for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners
and caps and do not operate this product until all
missing or damaged parts are replaced. Please con-
tact customer service or a qualified service center for
assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Before inspecting, cleaning or
Always wear eye protection with
When servicing, use only autho-
poor visibility. When you start the machine, the LED light
will automatically power on and illuminate the path in
front of you. When you stop the machine, the LED light
will automatically power off.
z Disconnect the extension cord after using the electric
snow shovel. Hang the extension cord with the shovel
so it will not be misplaced or damaged.
z When finished, allow the motor to run for an additional
few minutes, then turn the chute rotation lever back and
forth several times to remove any remaining snow from
the chute.
WARNING
ids, gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which can re-
sult in serious personal injury.
LUBRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
bearing lubrication is required.
STORING THE SNOW SHOVEL
CAUTION
may drip from the snow shovel is properly wiped up to
prevent a slip and fall hazard.
z Wipe the snow shovel with a clean dry cloth.
z Check all nuts, bolts, knobs, screws, fasteners, etc., for
tightness.
z Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
z Loosen the handle knobs and lower the upper handle
assembly.
z Store snow shovel indoors in a clean, dry place out of
the reach of children.
z Do not store near corrosive materials such as fertilizer
or rock salt.
|
English
13
Do not at any time let brake flu-
Make sure all melted snow that
Publicidad
