Rear Panel Features - Palmer DREI Manual De Usuario

REAR PANEL FEATURES

1 2
1
VOLTAGE SELECTOR
Select the mains voltage depending on the country you are in. Please
note that the mains fuse needs to be changed when operating this switch
(Please refer to the specifications above the mains socket) . Never oper-
ate this switch with a mains chord connected. A mains voltage mismatch
can damage the device.
2
MAINS IN AND MAINS FUSE
This is the socket for the included IEC power cord.
Caution: Do not operate the amp without the protective grounding connec-
tor!
The mains fuse can be located in a small drawer on the right of the sock-
et (the drawer is part of the socket).
Make sure to have the unit disconnected from the mains before opening
this drawer. Only replace the fuse with one of an identical type and rat-
ing.
3
ANODE FUSE
This holds the anode fuse for the power tubes. Replace with the same
type and value fuse only (see technical specifications). The power tubes
should be checked for defects if the anode fuse keeps blowing after re-
placement.
4
POWER AMPLIFIER OUTPUTS
For correct impedance matching the DREI provides 4, 8 and 16 Ohm loud-
speaker outputs.
Caution: Do not operate the amp without appropriate loads (4 Ohms mini-
mum) to prevent power amp damage. Make sure the loudspeaker impedance
matches the output impedance of the amp. Do not use loudspeakers rated
below the output power of the amp!
5
PALMER LOGO
This logo indicates that you amp has been hand made with love, care and
pride here in Neu-Anspach - Germany!
3 4 5
15 15