Publicidad
Idiomas disponibles
Idiomas disponibles
8.7
Measuring procedure
▪
Hold the tool at the point from which you want to measure. Press button 1 to turn on the
laser.
▪
The laser is aimed at the object to be measured. Press button 1 again to take a
measurement.
▪
To change the measuring unit, press 3 seconds on function key (2). You can choose
between inch, feet and meter.
▪
Note: the laser will switch off after 20 seconds of inactivity. Press on the on button (1)
again to turn device back on.
WARNING: Do not point the laser beam at persons or animals and do not
look into the laser beam yourself, not even from a large distance.
8.8
Single distance measurement
▪
Press the on button (1) to turn on the device. The tool will default to the single-distance
measuring mode.
▪
Press button 1 again to turn on the laser, the laser indicator will blink. Aim the laser at the
target you want to measure.
▪
Press button 1 again to take a measurement.
8.9
Continuous measurement
▪
The continuous measurement function is used for transferring measurements, e.g., form
construction plans. In the continuous measurement mode the measuring tool can be
moved relative to the target and the measured value is updated.
▪
Press button 1 a couple of seconds to enter the continuous measurement mode.
▪
Press button 1 again to measure operation. The measurement results will be displayed at
the most downtrend of the display screen.
8.10
Pythagorean theorem measurement
▪
Press button 2 to one time enter Pythagorean measurement mode. The Pythagorean
theorem icon (H) will be displayed.
▪
The hypotenuse that needs to be measured will start flashing. Press measuring key (1) to
shoot the laser and press again to measure the length of the hypotenuse. The length
value of the hypotenuse will be displayed on the screen.
▪
Another right angle that needs to be measured will start flashing. Press measuring key (1)
to measure the length of the right angle. The length value of the right-angle side will be
displayed in the middle row of the display screen.
▪
The length value of the side that needs to be measured will automatically be displayed in
the bottom row of the display screen.
8.11
Dual Pythagorean theorem measurement
▪
Press button 2 two times to enter dual Pythagorean measurement mode. The dual
Pythagorean theorem icon (I) will be displayed.
▪
One side of a triangle that needs to be measured will start flashing. Press measuring key
(1) to shoot the laser and press again to measure the length of the side. The length value
of the side will be displayed on the screen.
▪
Next, the vertical side that needs to be measured will start flashing. Press measuring key
(1) to measure the length of the vertical side. The length value of the right-angle side will
be displayed in the middle row of the display screen.
▪
The other side of the triangle will start to flash. Press measuring key (1) to measure this
side. The length value of the side that needs to be measured will automatically be
displayed at the bottom row of the display screen.
Copyright © 2023 VARO
KRT706500
P a g e
| 7
EN
www.varo.com
Publicidad
