Functional Description; Ground Fault Circuit Interrupter - Makita 4101RH Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.

Ground Fault Circuit Interrupter

1 R
T
2
003508
Connect the tool to a power supply and test the Ground
Fault Circuit Interrupter (GFCI) before using the tool.
Push the RESET (R) button and confirm that the pilot
lamp lights. Push the TEST (T) button and confirm that
the pilot lamp goes out. Push the RESET (R) button
again to use the tool.
WARNING:
Do not use the tool if the pilot lamp does not go out
•
when the TEST (T) button is pushed.
Adjusting the depth of cut
1
003510
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
Bevel cutting
1
003515
1. RESET (R)
3
Button
2. Pilot lamp
3. TEST (T) Button
1. Wing bolt
2. Base
2
1. Wing nut
Loosen the wing nut on the bevel scale plate on the front
of the base. Set for the desired angle (0° - 45° ) by tilting
accordingly, then tighten the wing nut securely.
Loosen the wing bolt on the depth guide and move the base
so that the end of the blade case is above the red line on the
depth guide. Then tighten the wing bolt to secure the base.
003516
NOTE:
If the end of the blade case is under the red line on
•
the depth guide, the outer flange may hit the
workpiece when you perform the bevel cut.
Sighting
2
003520
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
Switch action
1
003523
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
6
1. Wing bolt
1
2. End of blade
case
3. Red line
2
3
1
1. Base
2. Top guide
A
B
1. Switch trigger
2. Lock-off button
2