Beta 019670080 Manual De Instrucciones página 11

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
KEY TO SYMBOLS
1. Chuck
2. Mode selector
3. Reverse switch
4. Locking button
5. On/off button
6. Handle
7. Depth rod
ACCESSORIES
• Flat chisel (1 pc.)
• Straight chisel (1 pc.)
• SDS drill bits (3 pcs.)
USE
Power supply connection
For correct use, the plug of the electric tool must match the socket. Do not use any adapters with earthed electric tools. Check
that the power supply meets the specifications in the Technical Data table.
Operation
Do not press the start button before connecting the electric tool.
Discontinuous mode:
• Press on/off button (5) to start the electric tool.
• Release on/off button (5) to stop the electric tool.
Continuous mode:
• Press on/off button (5) to start the electric tool and lock it by
means of locking button (4).
• Press and release on/off button (5) to unlock and stop the
electric tool.
Speed regulation
• Increase pressure on on/off button (5) to increase the tool speed.
• Decrease pressure on on/off button (5) to reduce the tool speed.
Setting direction of rotation
Check that button (5) has been released from the locking position and that the motor is not running. Select the direction of
rotation of the electric tool by means of reverse switch (3), as shown below.
- Clockwise direction: shift reverse switch (3) to the symbol
- Anticlockwise direction: shift reverse switch (3) to the symbol
Operating mode selection
Select the operating mode by means of selector (2) as follows:
Boring mode
• For boring in steel and wood, position the knob of selector (2) as shown below.
EN I
11