Publicidad
Idiomas disponibles
Idiomas disponibles
Bl
DO NOT MAKE ANY ATTEMPT TO
OPERATE THE ELECTRIC IGNITION OVEN DURING
AN ELECTRICAL POWER FAILURE. RESETALL OVEN
CONTROLS TO "OFF" IN THE EVENT OF A POWER
FAILURE.
The electric ignitor will automatically re-ignite the oven
burner when power resumes ifthe oven thermostat control
was left in the "ON" position.
When an electrical power failure occurs during use, the
surface burners will continue to operate.
During a power outage, the surface burners can be lit
with a match. Hold a lighted match to the burner, then
slowly turn the knob to the x
(lite) position. Use extreme
caution when lighting burners this way.
1-1/8" Dia.
7/8" Dia.
Knockout
Hole
(See Chart)
(See Chart)
Mounting
1-3/8" Dia:
Range Connection Opening Size Chart
Supply cord kit ampere rating information.
RANGE INSTALLATIONS STEPS
Access the terminal block
The rear access cover must be removed. To remove, loosen
center screw (one screw) and
remove
access cover. The
terminal block will then be accessible (See Fig. 25).
Remove
|
Access
Rear
Cover to install
of Range
Power Cord.
Replace after
installation.
Fig. 25
See serial plate on range for
Diameter (inches)
kilowatt (kw) rating
of range conenction
opening
120/240 Volts | 120/208 Volts | Cord Kit | Cord kit | Perma-
Ampere
nent
Rating
wiring
8.8-16.5 kw
7.9-12.5 kw
40/50
1-3/8 in | 1-1/8 in
Amp
16.6-22.5 kw | 12.6-18.5 kw | 50 Amp | 1-3/8 in | 1-3/8 in
Fig. 27
Power
-
Cord Strain
Relief Bushing
Separate Power Cord
Strain Relief Bushing
before installation
Install Strain
"=.
Relief Bushing—~
with Power
Cord as shown
Publicidad
