Foppapedretti CLEVER i-Size Manual De Instrucciones página 28

ASSEMBLING THE CAR SEAT (Fig. 1)
Align the seat and backrest connectors as shown in the figure.
Attach the backrest hooks to the seat brackets.
Lift the backrest vertically while pressing on the connectors.
WARNING: DO NOT APPLY EXCESSIVE FORCE TO THE CONNECTORS TO AVOID
DAMAGING THE PRODUCT.
DISASSEMBLY THE CAR SEAT (Fig. 2)
Push the backrest into a horizontal position, unhook it from the seat by lifting it.
ADJUSTING THE HEADREST (Fig. 3, 4)
A correctly adjusted headrest ensures that the diagonal seat belt section is optimally
positioned, and gives your child the optimal protection.
The headrest must be adjusted so that there is a space two fingers wide between the
headrest and your child's shoulders.
To adjuste the height of the headrest to fit your child:
Reach into the adjustment handle on the back of the headrest and pull it upwards.
•
This unlocks the headrest.
Adjust the headrest to the desired height. The headrest will lock in the new position
•
as soon as the handle is released.
The headrest must be adjusted in such a way as to allow the diagonal belt to rest on
the child's shoulder, neither too low nor too high. Ensure that the headrest is locked
into place in the chosen position and that the seat belt is not touching the child's neck.
INSTALLING WITH 3-POINT SEAT BELT
• Fig. 5 Position the seat facing towards the direction of travel on the passenger seat.
Make sure the back of child seat is against the backrest of vehicle seat firmly.
• Fig. 6 The vehicle's 3-point seat belt must be inserted into diagonal belt guide "A"
and into lap belt guides "B" and "C" as shown in the figure.
• Fig. 7 Place the child in the ar seat and adjust the height of the headrest according
to the size of the child (see step 9 "Adjusting the headrest").
• Fig. 8 Remove the vehicle seat headrest if it prevents you from adjusting the car seat
headrest to the desired height.
• FIg. 9 Secure the child with the 3-point seat belt supplied with the car, passing the
diagonal belt of the vehicle through the upper belt guide loop (A) and the lap belt of
the vehicle through belt guide loops (B) and (C) (see figure C9).
• FIg. 10 Clip the buckle, a "click" will indicate that it is correctly fastened.
• Fig. 11 Tighten the belt as shown in the figure. Make sure that you have positioned
the lap belt as low as possible on the child's pelvis, and that it has been inserted in
• ENGLISH •
USE IN THE VEHICLE
28