BEARWARE 305273 Manual Del Usuario página 23

Pressing the "SET" button briefly activates the night mode (the default setting is
"OFF"). You can change the value by pressing the "UP" or "DOWN" buttons. The
night mode is switched on if you select the "ON" option. It automatically changes
to the low brightness mode on the next day from 18:00 hrs to 6:00 hrs.
Automatic dimming
When the night mode is switched "ON", press and hold "SET" button for 3 sec-
onds to enter the interval time setting mode. The setting sequence is "Start hour"
- "Start minute" - "End hour" - "End minute".
The upper point is bright for a long time in the centre of the screen in the "Start
hour" and "Start minute" setting. The lower point is bright for a long time in the
centre of the screen in the "End hour" and "End minute" setting.
Note: If automatic dimming is activated, then the night mode does not work
(from 18:00 hrs to 6:00 hrs).
14. Thermometer & humidity display
• The default unit of temperature is °C.
• Press and hold the "DOWN" button for 3 seconds to change the unit from
°C to °F.
• The indoor temperature range is: 0°C - 50°C (32°F - 122°F).
• The indoor humidity is: 20%-95%.
15. Charging port
A Type-A USB charging port is provided at the back of the clock.
You can use this charging port, for example, to connect the charging cable of your
smartphone and charge it.
Please note that only the Type-A USB port is intended as a charging port.
English
23