Publicidad
Idiomas disponibles
Idiomas disponibles
5.4.2
Remove vacuum grid (front filter) and clean by removing coarse dirt and dust. In case the net is torn, it
is recommended to change it.
Put your fingers inside the hole and remove the filter cover plate from work area by pulling to front
sinuously. Clean this part from coarse dirt and dust in the same way.
Remove fibre filter from its location and clean it by shaking, vacuuming with vacuum cleaner, washing or
change it depending on its level of contamination.
Remove the filter support plate and clear dust if it necessary.
Lastly, remove the complete frame from the body along with Z-Line filter and clean these filters by
shaking, vacuuming with vacuum cleaner or change them.
Re-assembly is done from bottom to the top; starts with Z-line cartridge filter and ends with suction grid.
We kindly request you to pay attention that all parts are placed on the frame in correct order and in the
right way.
Filter material we use are harmless in terms of health and ecology, silicon-free, fully flammable, can be
heated up to 80° C, can spontaneously extinguish in accordance with DIN 53438 / F1 and resists to
humidity up to 100%.
Polishing machine POLYTEC by PRECITEC® / MSA23.005 / User manual / All rights reserved
FILTER SYSTEM CLEANING
Do not squeeze washed filters!
Insufficient cleaning or rare changing of filters may cause
damages on suction system.
We kindly request that the device is unplugged during installation
and equipment changing.
11
Publicidad
