TFA 60.2536 Instrucciones De Uso página 13

TFA_No. 60.2536_Anleit_01_24
Radio-controlled alarm clock
• When the adjusted alarm time is reached, the alarm will ring.
• Press any button to stop the alarm or press SNOOZE/LIGHT on the top of the
instrument to activate the snooze function.
• If the alarm is not stopped manually, the ascending alarm tone automatically
turns off after two minutes and will be reactivated at the same set time.
remains on the display.
• If the snooze function is activated, Zz will be flashing on the display.
• The alarm will be interrupted for 5 minutes.
• The snooze function can be activated up to seven times.
• To deactivate the alarm function, slide the ALARM switch downwards (OFF).
• The alarm symbol
7.4 Backlight
• Press SNOOZE/LIGHT at the top and the backlight will be activated for 5 sec-
onds.
• Move the AUTO LIGHT ON/OFF switch to ON, a weak backlight turns on auto-
matically as soon as the light sensor registers darkness.
8. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring
agents.
• Remove the batteries if the device will not be used for an extended period of
time.
• Keep the device in a dry place.
24
22.01.2024 9:57 Uhr
disappears.
Seite 13
Radio-controlled alarm clock
8.1 Battery replacement
• Change the batteries when the display becomes weak.
• Open the battery compartment and insert two new AA 1,5 V batteries.
• Make sure the polarity is correct.
• Close the battery compartment again.
9. Troubleshooting
Problem
No display on the device
No DCF reception
Incorrect indication
If your device fails to work despite these measures contact the retailer where you
purchased the product.
Solution
➜ Ensure the batteries polarity are correct
➜ Change the batteries
➜ Press and hold the – button for three
seconds and start the initialization
manually
➜ Choose another place for your product
➜ Set the clock manually
➜ Wait for an attempt reception during
the night
➜ Check if there is any source of interference
➜ Restart the instrument according to
the manual
➜ Use a pin to press the RESET button
➜ Change the batteries
25