Publicidad
Idiomas disponibles
Idiomas disponibles
COLD WEATHER STARTING
(50 ° Fand
below)
6. When engine s tarts, leave t hrottle
control inchoke position until e ngine
warms u pandbegins t orunroughly.
Once rough r unning b egins, immedi-
ately move the throttle c ontrol tothe
fast p osition. Engine w arm-up may
take from several seconds toseveral
minutes ( the colder thetemperature,
thelonger thewarm-up).
AUTOMATIC
TRANSMISSION
WARM UP
Before d riving t heunit i ncold weather,
thetransmission
should bewarmed u pas
follows:
1. Besure thetractor i sonlevel g round.
2. Release theparking b rake a ndtetthe
brake slowly r eturn tooperating posi-
tion.
3. Allow oneminute f ortransmission
to
warm up.This canbedone during
theengine w arm upperiod.
The attachments
canalso beused dur-
ingtheengine w arm-up period a fter t he
transmission
hasbeen warmed u p.
NOTE:If ata high altitude (above 3 000
feet) o rincold temperatures
(below 32° F)
thecarburetor fuel m ixture m ay need tobe
adjusted forbest e ngine p erformance
(see
"TO ADJUST CARBURETOR"
inthe Service
andAdjustments
section o fthismanual).
RGE
TRANSMiSSiON
CAUTION:
Never engage or dis-
engage freewheel lever while the engine
is running.
To ensure proper operation and per-
formance, it is recommended
that the
transmission
be purged before operating
tractor for the first time. This procedure will
remove any trapped air inside the trans-
mission which may have developed during
shipping of your tractor.
IMPORTANT:
Should your transmission
require removal for service or replace-
ment, it should be purged after reinstalt-
ation before operating the tractor.
1. Place tractor safely on a level surface
- that is clear of objects and open - with
engine off and parking brake set.
2. Disengage transmission by placing
freewheel control in disengaged
posi-
tion (See "TO TRANSPORT"
in this
section of manual).
3. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to stow position. Disen-
gage parking brake.
,_I, CAUTION: At any time, during step
4, there may be movement of the drive
wheels.
4. Depress forward drive pedal to full
forward position and hold for five (5)
seconds and release pedal. Depress
reverse drive pedal to full reverse posi-
tion and hold for five (5) seconds and
release pedal. Repeat this procedure
three (3) times.
5. Shutoff engine and set parking brake.
6. Engage transmission
by placing free-
wheel control in engaged position (See
"TO TRANSPORT"
in this section of
manual).
7. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to half (1/2) speed.
Disengage parking brake.
8. Drive tractor forward for approximately
five feet then backwards for five feet.
Repeat this driving procedure three
times.
Your transmission is now purged and now
ready for normal operation.
MOWING
TIPS
• Tire chains cannot be used when the
mower housing is attached to tractor.
Mower should be properly leveled for
best mowing performance.
See "TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
The left hand side of mower should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has already been
cut. Have the cut area to the right of
the tractor. This will result in a more
even distribution of clippings and more
uniform cutting.
• When mowing large areas, start by
turning to the right so that clippings will
discharge away from shrubs, fences,
driveways, etc. After one or two rounds,
mow in the opposite direction making
left hand turns until finished.
15
Publicidad
