Publicidad
Idiomas disponibles
Idiomas disponibles
Clutch/brake
pedal
Clean
top side
Steering
CAUTION:
\
Steering System, Dash,
&
Pinch
o.
Points
Fender and Mower Not Shown
•
Keep finished surfaces and wheels
free of all gasoline, oil, etc.
•
Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose
or pressure washer to clean your tractor
unless the engine and transmission
are
covered to keep water out. Water in engine
or transmission will shorten the useful life of
your tractor.
Use compressed air or a leaf
blower to remove grass, leaves and trash
from tractor and mower.
DECK WASHOUT
PORT
Your tractor's
deck
is equipped
with a
washout port on its surface as part of its
deck wash system. It should be utilized af-
ter each use.
1.
Drive the tractor to a level, clear spot
on your lawn, near enough to a water
spigot for your garden hose to reach.
IMPORTANT:
Make certain the tractor's
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove
bagger chute or mulch cover if attached.
2.
Make sure the PTO (Blade Engage) is
not engaged, set the parking brake, and
stop the engine.
3.
Thread the nozzle adapter (packaged
with your tractor's Operator's Manual)
onto the end of your garden hose.
4.
Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck. Release the lock collar to
lock the adapter on the nozzle.
Nozzle
Ads
Washout
Port
IMPORTANT:
Tug hose ensuring connec-
tion is secure.
5.
Turn the water on.
6.
While sitting in the operator's position
on the tractor, re-start the engine and
place the throttle lever in the Fast ",_"
position.
IMPORTANT:
Recheck
the area making
certain the area is clear.
7.
Move thetractor'sPTO(BladeEngage)
to the ON position. Remain in the op-
erator's
position
with the cutting deck
engaged until the deck is cleaned.
8.
Move thetractor'sPTO(BladeEngage)
to the OFF position. Turn the ignition
key to the STOP position to turn the
tractor's engine off. Turn the water off.
9.
Pull back the lock collar of the nozzle
adapter to disconnect the adapter from
the nozzle washout port.
10. Move the tractor to a dry area, prefer-
ably a concrete or paved area. Engage
the mower deck PTO to remove excess
water and to help dry before putting the
tractor away.
_WARNING:
A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
Replace broken or missing washout fitting
immediately, prior to using mower again.
Plug any holes in mower with bolts and
Iocknuts,
21
Publicidad
