Descargar Imprimir esta página

Num'axes SOL1072 Manual De Instrucciones página 9

Panel solar 6v/9v/12 v con batería interna

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

• Technical specifications
Built-in battery
Solar panel max output power
Output voltage
External load input
Output cable
Charging methods
Full charge time
Charging indicator
Watertightness
Operation temperature
Dimensions
• Fonctionnement
1. Before use, fully charge the solar panel battery using a power supply (DC 5V/2000 mA - ref.
NUM'AXES CPELEALI052) and a cable (type-c - ref. NUM'AXES NGPIEACC0552) not supplied.
Use the female socket (no. 4 on the diagram) to charge/recharge the solar panel battery.
2. Once the solar panel battery is full, plug the male connector (no. 3 on the diagram) and the
female connector (no. 4 on the diagram) into each other and tighten the plastic ring to prevent
any water penetration.
3. When the solar panel battery is charging, the indicator light is red or alternately red and
green.
Red and green if the charge level is < 3V (battery heavily discharged during slow recharging)
Fix red if the charge level is > 3V (rapid recharging)
When the solar panel battery is full, the indicator light is green.
• Connecting the solar panel to the trail camera
Connect one end of the output cable (n°5 on the diagram) to the solar panel output socket
(OUT) (n°2 on the diagram), then connect the other end of the cable to the external power
socket on your NUM'AXES camera trap. Depending on the model of camera trap, choose the
adaptor supplied.
Use the selector switch to choose 6V, 9V or 12V (n°5 on the diagram) depending on the camera
trap you're connecting.
If the internal battery of the solar panel is charged, the camera will be immediately powered.
It is strongly recommended that 4 batteries be installed inside the camera even when connected
to the solar panel. Otherwise, the camera may stop operating due to power shortage. During
Guide panneau solaire SOL1072 – NGPIEACC069 – Ind. A – Nov. 2023 - 9/28
2 lithium batteries 18650 3,7V / 5200 mAh
3 W
6V/9V/12 V
DC 5 V/2000 mA
Length 2,50 m/8,20 ft
1. With solar energy
2. With AC power adaptor (non included)
1. 24 hours for sunlight charging
2. 4 hours for 5V/2A adapter (charging the
solar panel with the Type-c)
Red light: fast charge (charge level > 3 V)
Flashing red and green: slow charge (charge
level < 3 V)
Green light: fully charged
IP66
-20°C to +70°C
H 173 x L 120 x P 35 mm

Publicidad

loading

Productos relacionados para Num'axes SOL1072