Publicidad
Idiomas disponibles
Idiomas disponibles
Problem and alarm code
Small leak from the appliance door.
The appliance door is difficult to
close.
The appliance door opens during
the wash cycle.
Rattling or knocking sounds from
the inside of the appliance.
The appliance trips the circuit-beak‐
er.
The appliance is switched on but
does not operate.
The display shows PF.
The appliance switches off during
operation.
The display shows upd. All buttons
are inactive except for the on/off
button.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
WARNING!
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
Possible cause and solution
•
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
•
The appliance door is not centred on the tub. Adjust the rear foot (if ap‐
plicable).
•
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
•
Parts of the tableware are protruding from the baskets.
•
The AirDry function is activated. You can deactivate the function. Refer
to "Basic settings" chapter.
•
The tableware is not properly arranged in the baskets. Refer to basket
loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all the applian‐
ces in use. Check the socket amperage and the capacity of the meter
or turn off one of the appliances in use.
•
Internal electrical fault of the appliance. Contact an Authorised Service
Centre.
•
Power supply is out of the operating range. The dishwashing cycle is
temporarily interrupted and resumes automatically once the power is
restored.
•
Complete power outage. The dishwashing cycle is temporarily interrup‐
ted and resumes automatically once the power is restored.
•
The appliance downloads and installs the firmware update automatical‐
ly when it is available. The display shows upd for the duration of the
updating process. Wait for the process to be complete. If you interrupt
the update process by deactivating the appliance, it resumes when you
activate the appliance.
The firmware update does not change the appliance performance dec‐
laration values.
13.1 The product number code
(PNC)
If you contact an Authorised Service Centre,
you need to provide the product number code
of your appliance.
The PNC can be found on the rating plate on
the appliance door. You can also check the
PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously
for about 3 seconds.
ENGLISH
and
27
Publicidad
