Publicidad
Idiomas disponibles
Idiomas disponibles
control code as follows.
Remote-Control Signals" on page 8.
Operating Procedure
= Example: To recall JVC camcorder code for
playback VCR/camcorder
. Press the SET button @ with sharp tip
S
of a pen, etc.
2. The SET indicator @ starts blinking.
3. While pressing the EDIT STOP button SET
©, press the REW button @ among the playback
VCR/camcorder
control buttons four times. The
SET indicator blinks.
—h
Press 4 times
Press first,
and keep it
pressed
Note: If the REW button is pressed before pressing
the EDIT STOP button, the memorization function
will be engaged. Re-execute from the beginning.
4. Release both buttons.
5. The blinking SET indicator glows steadily, then goes
out.
6. Now the setup for the playback VCR/camcorder is
complete.
JVC remote-control code setup table
Code to recall
Note:
PLAYER control
area
A
Cc
Camcorder
m Example: To recall JVC "A" code for recording
VCR
1. Press the SET button @ with the sharp tip of a pen,
etc.
2. The SET indicator @ starts blinking.
3. While pressing the EDIT STOP button @, press the
REW button @ among the playback VCR/camcorder
control buttons once.
4. Release both buttons.
5. The blinking SET indicator @ glows steadily, then
goes out.
6. Setup for the recording VCR is complete.
Notes:
@ When recalling another brand model's
preset code, press the required button
instead of button @ used in the above
example
by referring to ""Remote-
Control Code Setup Table" on page 19.
e When
the R.A.E. switch inside the
battery compartment is set to ON, only
the JVC remote-control codes are
available for the playback
VCR/
camcorder.
correctly by pressing VCR control buttons.
ENGLIS
Publicidad
