Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Place the cavity side of the hopper against the bottom of
the cabinet and align the holes. Insert (6) bolts (A) from the
inside of the cabinet in the locations shown below. Push
the bolts through the seal material and install nuts (B). Do
not tighten.
5.
Install the short legs (K) by placing at one of the base
corners and align the holes. Insert bolt (A) from the inside
of the cabinet into the (4) mounting holes. Push the bolts
through the seal material and install nuts (B). Do not
tighten. Repeat process for the other (3) legs. Once all (4)
legs are installed, tighten all fasteners securing legs and
hopper to cabinet. Close and latch door.
Determine if your cabinet will be configured as a benchtop
model or as a stand alone floor model. For benchtop configu-
ration, install feet (L) onto bottom of the legs and proceed to
Step 9. For a stand alone floor model, continue to Step 6.
6.
Install the long legs (M) to the inside of the short legs using
(4) of bolt (C) and nut (D) using the (2) inner holes of the
short leg. Repeat with the other (3) legs and tighten all
fasteners.
8
Publicidad
