8. WHAT IF THERE ARE PROBLEMS?
Problem
Possible cause
The load on the
2
Massage heads
,
massage heads
4
are rotating too
2
,
slowly.
great.
The massage was
2
Massage heads
only activated for
4
,
are rotating in
the limited area in
the upper or lower
question.
area only.
The device is
2
Massage heads
,
not connected
4
are not moving.
to mains power
supply.
Device not
switched on.
Overheating
protection trig-
gered, device is
damaged.
The neck section
The PRESS button
1
3
cannot be
has not been
adjusted
pressed.
9. DISPOSAL
For environmental reasons, do not dispose of the device in house-
hold waste at the end of its service life. Dispose of the
device at a suitable local collection or recycling point in
your country. Observe the local regulations for material
disposal. Dispose of the device in accordance with EC
Directive Waste Electrical and Electronic Equipment
(WEEE). If you have any questions, please contact the local au-
thorities responsible for waste disposal. You can obtain the loca-
tion of collection points for old devices, for example, from the local
or municipal authorities, local waste disposal companies or your
retailer.
10. TECHNICAL SPECIFICATIONS
Power supply:
100-240 V~, 50/60 Hz, 36 W
Dimensions:
Back (including neck): 59 x 14 x 95 cm
Seating surface 59 x 9 x 50 cm
Weight:
Approx. 6.8 kg
11. WARRANTY
Further information on the warranty and warranty conditions can
be found in the warranty leaflet supplied.
Solution
Reduce the contact
pressure from your
4
is too
body.
Press the UPPER
BACK button (upper
back)
or the
11
LOWER BACK but-
ton (lower back)
to change/expand
the area.
Connect the mains
plug and switch on
the device.
Switch on the
device using the
ON/OFF button
Select the massage
area.
Contact your re-
tailer or the service
address.
Press the PRESS
3
button
to
release the neck
section.
12
18
.
16