Troubleshooting Guide - DeWalt DCS361 Manual De Instrucciones

TROUBLE! WHAT'S WRONG?
Saw will not start 1. Battery not installed
2. Battery not charged
3. Brushes worn out
Saw makes unsatisfactory cuts 1. Dull blade
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being
XPS™ worklight is flashing 1. Battery not charged
Machine vibrates excessively 1. Saw not mounted securely to
2. Stand or bench on uneven floor
3. Damaged saw blade
Does not make accurate miter 1. Miter scale not adjusted correctly
cuts
2. Blade is not square to fence
3. Blade is not perpendicular to
4. Workpiece moving
5. Kerf plate worn or damaged
Material pinches blade 1. Cutting bowed material

Troubleshooting Guide

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT TO DO
1. Install battery. Refer to Installing and Removing Battery Pack.
2. Charge battery. Refer to Charging Procedure.
3. Have brushes replaced by authorized service center.
1. Replace blade. Refer to Changing or Installing a New Saw Blade.
2. Turn blade around. Refer to Changing or Installing a New Saw Blade.
3. Remove blade and clean with coarse steel wool and turpentine or household oven cleaner.
4. Change the blade type. Refer to Saw Blades under Optional Accessories.
done
1. Charge battery. Refer to Charging Procedure.
1. Tighten all mounting hardware. Refer to Bench Mounting.
stand or work bench
2. Reposition on flat level surface. Refer to Familiarization.
3. Replace blade. Refer to Changing or Installing a New Saw Blade.
1. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
2. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
3. Check and adjust fence. Refer to Bevel Square to Table Adjustment under Adjustments.
table
4. Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
5. Take to authorized service center.
1. Refer to Bowed Material under Special Cuts.
17