At The End Of A Cleaning Session; Maintenance, Cleaning And Decontamination; Filter Disassembly And Replacement; Filter Cartridge Replacement - Javelin BDC-3140P Manual De Instrucciones

BDC-3140P

At the end of a cleaning session

■ Turn off the vacuum cleaner and remove the plug from
the socket.
■ Wind the connection cable around the cable carrier
(Figure 8).
■ Empty the container as described in the "Emptying
the container" paragraph. Clean the vacuum cleaner
as described in the "Maintenance, cleaning and
decontamination" paragraph.
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized people.
Maintenance, cleaning and
decontamination
The precautions described below must be taken
during all the maintenance operations, including
cleaning and replacing of the filters.
■ To allow the user to carry out the maintenance
operations, the vacuum cleaner must be
disassembled, cleaned and overhauled as far as
is reasonably possible, without causing hazards
for the maintenance staff or other people. The
suitable precautions include decontamination
before disassembling the vacuum cleaner,
adequate filtered ventilation of the exhaust
air from the room in which it is disassembled,
cleaning of the maintenance area and suitable
personal protection.
Compartments that are not dust-tight must be opened
with suitable tools (screwdrivers, wrenches, etc.) and
thoroughly cleaned.
■ Carry out a technical inspection at least once a
I
year, for example: check the filters to find out
whether the air-tightness of the vacuum cleaner
GB
has been impaired in any way and make sure
that the electric control panel operates correctly.
This inspection must be carried out by the
F
manufacturer or by a competent person.
D
Use only genuine spare parts supplied and authorized
E
by the manufacturer.
C324
WARNING!
WARNING!

Filter disassembly and replacement

WARNING!
When the vacuum cleaner is used to vacuum
hazardous substances, the filters become
contaminated, thus:
■ Work with care and avoid spilling the vacuumed
dust and/or material;
■ Place the disassembled and/or replaced filters in
a sealed plastic bag;
■ Close the bag hermetically;
■ Dispose of the filters in accordance with the laws
in force.
WARNING!
Filter replacement is a serious matter. The filters must
be replaced with ones of identical filtering surface
characteristics.
Otherwise the vacuum cleaner will not operate
correctly.

Filter cartridge replacement

1 Vacuum hose
2 Fixing clamp
3 Compressed air hose
4 Electric cable
5
Electric connector
6 Release lever
7 Cover
8 Filter cartridge support
9 Filter cartridge
10 Filter cartridge fixing nut
Before proceeding with these operations, turn off the vacuum
cleaner and remove the plug from the power socket.
■ Remove the vacuum hose (1) and its clamp (2).
■ Disconnect the compressed air hose (3) by releasing its
quick-fit coupling.
■ Disconnect the electric cable (4) by releasing the connector
(5).
■ Use the lever (6) to remove the cover (7).
■ Remove the support (8) with the filter cartridges.
■ Remove the filter cartridges (9) by unscrewing the fixing nuts
(10).
■ Assemble the new filter cartridges and proceed in the
reverse order of removal to install all the components,
making sure that the previously disconnected electrical
and pneumatic connections have been reconnected.
When reassembling, turn the cover until the
electropneumatic device is in the right position for the
cartridge support.
■ Dispose of the old filter cartridges according to the laws
in force.
8
Figure 10
07/2008