CLS Wallstation
Reassembling the control plate
1.
Place the inner plate onto the main body (noting the
orientation arrow). With the plate in place, insert and lightly
tighten the two retaining screws.
T O
2.
Attach the top edge of the front cover to the main body.
3.
Angle the front cover down and press the lower part of it
against the inner plate until it clicks into place
Ambient atmosphere requirements
Temperature: 32
F to 104
F (0
C to +40
0
0
0
Humidity: 0 to 95% non-condensing
FM 664349
P
T O
P
C)
0
Cooper Lighting Solutions
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com
For service or technical assistance:
1-800-553-3879
FCC Statement
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 Clause 15.21
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC Part 15.19a
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC 2.1093/RSS-102
This product complies with the RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual.
ISED RSS
This device complies with Industry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause interference;
and (2) This device must accept any interference, including interference that may
cause undesired operation of the device. CAN ICES-3 (B)/NMB-3(B)
Warranties and Limitation of Liability
Please refer to www.cooperlighting.com/global/resources/
legal for our terms and conditions.
© 2024 Cooper Lighting Solutions
Canada Sales
All Rights Reserved.
5925 McLaughlin Road
Mississauga, Ontario L5R 1B8
Product availability, specifications,
P: 905-501-3000
and compliances are subject to
F: 905-501-3172
change without notice.
WaveLinx Wired
IB50316524 page 4
February 2024