Publicidad
Idiomas disponibles
Idiomas disponibles
You can check the product features in table
01 on page 7.
ASSEMBLY AND INSTALLATION
Before unpacking the product, memorize
the position of each accessory in case you
need to repack it in the future.
The fan is packed with the grilles removed.
You must place the grilles before operating
the fan.
Warning: Never operate the fan without its
base or other parts.
Operate the fan only in an upright position;
any other position could create a dangerous
situation.
Assemble the base and other parts of the
appliance considering the following notes.
Note: the images are for guidance only and
should be used to support the installation.
(
See picture 03 on page 5-6)
• Unpack and take out every part of the
fan.
• Screw the fan body (11) to the base (14),
then cover it with the base cover (13).
(Fig. 1)
• Insert the fan head (7) into the fan body
(11) (Fig 2).
• Adjust the head as far as possible with
the adjusting screw (8), which is located
on the side. (Fig. 3)
• To set the desired height, it must be
positioned using the height adjustment
(12). Slide the rear grille (5) onto the
motor shaft (6) and adjust with the rear
fixing nut (4). (Fig. 4).
• Place the blades (3) on the motor shaft
(6) and tighten them with screws (Fig.
5).
• Fit the front grille (1) to the rear grille (4) and
use the fasteners to join the two (Fig. 6).
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 02 on page 5)
15. Activation tab. The fan is switched
on/off by turning the tab. To turn it
off, place it on the number 0; to turn
it on, place it on the numbers 1, 2 and
3, depending on the desired speed.
16. 0/Off. Position for switching off the
fan.
17. 1/Low speed.
18. 2/Medium speed.
19. 3/High speed.
• The oscillation button (9) is located on
the side of the fan head (7).:
• To activate: Push the button inwards,
the fan head will start to rotate in
a wide angle (360º oscillation) to
optimise air distribution in the room.
• To
deactivate:
outwards to cancel this function.
• If you wish to keep the angle of the
head in a fixed position, simply activate
the oscillation function and deactivate
it when the rotation has reached the
desired position. For this, follow the
steps above.
CLEANING AND MAINTENANCE
To clean it, please follow the instructions
below:
• Turn the fan off and wait until it has
stopped completely.
• Disconnect it from the power supply.
• Be careful to prevent any liquid from
getting inside the appliance.
• Use only a soft damp cloth.
• Do not allow water at a high temperature
in contact with the plastic parts.
• Do not use abrasive cleaners. You can
use a neutral detergent.
• When you have finished cleaning it,
assemble it again and store it in a dry
place.
• If you are not going to use the fan
for some time, it is recommended to
remove the batteries from the remote
EN
pull
the
button
21
Publicidad
