Descargar Imprimir esta página

SUHNER ABRASIVE SHS 1330 Flat Documentación Técnica página 29

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
the mount from the head piece. Pull the spacer sleeve out
of the mount.
Loose the screw and remove the lever.
Unscrew the pipe of the flexible shaft and decompose
it into parts. The coupling is provided with a left hand
thread. Clean the parts thoroughly with a brush and de-
tergent. Rinse with water and let it dry. Do not use ag-
gressive detergent! To connect the hand pieces, follow
the above instructions in reverse order. After connecting,
press the grease cup button two to three times.
4.1.2 r
egrinding the BlAde
The blade can be reground with a com-
mercially available grinding machine.
There are special adapter plates available
for SUHNER blades.
V
ery shArp BlAde
4.1.3 h
Ardening the BlAde
resentative or directly from the manufacturer. Apply the
steel under a light pressure. The last pass should be
along the inside of the blade. When cutting does not im-
prove, the blade must be replaced. Contact the area rep-
resentative or the manufacturer for further information.
!
Exclusively SUHNER steel
must be used. This can be
purchased from the area rep-
O
utside edge
Make sure that the steel is held flat and over the blade's
centre line.
i
nside edge
The inside edge is hardened at the press of the button
when the machine is running. At the same time the hand
piece must be held downwards or away from the user.
4.1.4 h
Oning the BlAde
Before honing, clean the hand
piece of all fat and meat residue.
The blade must be honed every day with a knife sharp-
ener or a stone.
29

Publicidad

loading