Craftsman 919.167243 Manual De Instrucciones página 10

Contents of Carton
1 - Air Compressor
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, .25 x 1.50
1- Handle
1 - Handle Grip
2 - Screws, #10-16 x 1.00
Tools Required for
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
installing Handles,
Wheels, and Molded Foot
"swhee's
handle
do not provide adequate c_earance,
staMity or support for pulling the
unit up and down stairs or steps,
The unit must be lifted, or pushed
up a ramp,
1. Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
It will be necessary
to brace or
support one side of the outfit when
installing the wheems because the
compressor will have a tendency to
tip over.
3. InstalI one shoulder bolt
and one nut for each wheel.
Tighten securely. The outfit
wilI sit leve! if the wheels are
properly installed.
Wheel
4.
Clean and dry underside of
air tank Ieg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of Ieg
on each end. Press firmly into
place.
Molded Foot
Handle Screw
A08599 10-ENG