Publicidad
Idiomas disponibles
Idiomas disponibles
EXPOSED PARTS INSTALLATION
B
- With the coating finished remove the protections.
- Insert the molded flange (1) on the support (2).
- Screw manually the support (2) tightening it slightly; position the molded flange (1) as shown
in table A.
- Insert the headvalve cover cap (3) on the support (2) and fasten it tightening the dowel (4).
- Insert the plate (5).
- Assemble the plastic ring (6), the hole cover plate (7) and the handle (8).
- Fasten the handle tightening the dowel (9).
- Remove the plug (10); screw the sleeve (11) flush with the wall (as shown in table B)
and level it. Use hemp or PTFE (Teflon) for hydraulic tightness.
- Insert the supply spout (12) in the sleeve (11) and fasten it tightening the dowel (13).
- Open the supplies of the waters and check the proper operation of the tap.
12
Publicidad
