Motorline professional TEC1 Manual Do Utilizador página 6

METHOD OF USE
The use of the keypad is based on "combinations", i.e. numbers of from 1 to 9 digits that the user is
required to key in by means of the keys. Once the combination has been entered the user then presses
confirm key or , to transmit the activation command to, respectively:
• Receiver channel 1 if the user presses
• Receiver channel 2 if the user presses
The command will be transmitted only when a valid combination has been entered: if an incorrect
combination has been entered the selector will emit an error, warning signal when the confirm key is
pressed . The combination entered must be exact, if, for example ,the correct combination is 0422, the
following attempts will be interpreted as errors: 422, 10422, 04222. Therefore, if the user inadvertently
presses the wrong key when entering a combination, combination key
immediately to generate the error tone , after which the correct combination can be entered starting
from the beginning again.
While entering the combination no more than 6 seconds can be allowed to elapse between keystrokes,
after which interval the combination must be re-entered starting from the beginning.
The factory set combinations are as follows:
• When the unit is used for the first time this combination is 11
• When the unit is used for the first time this combination is 22
CHANGING A COMBINATION
TABLE A CHANGING THE COMBINATION ASSOCIATED WITH CHANNEL 1 ( )
This function allows you to change the combination associated with channel 1 ( ):
1 • Press the "0" key and hold it down while pressing and releasing ;
2 • Release the "0" and
keys;
3 • Type in the current (original) combination and press
used);
4 • Type in the new combination (up to 8 digits ) pressing ;
5 • Type in the new combination again and press
operation's sucess. If it emits several beeps, repeat the operation).
TABLE B CHANGING THE COMBINATION ASSOCIATED WITH CHANNEL 2 ( )
This function allows you to change the combination associated with channel 2 ( ):
1 • Press the "0" key and hold it down while pressing and releasing ;
2 • Release the "0" e keys;
3 • Type in the current (original) combination and press
used);
4 • Type in the new combination (up to 8 digits ) and press
5 • Type in the new combination again and press
operation's sucess. If it emits several beeps, repeat the operation).
If the two combinations you have entered are identical, once you have entered the
combination you can press either
or should be pressed
(Original - 11, or the code that was being
(the keyboard will emit one long beep confirming the
(Original - 22, or the code that was being
;
(the keyboard will emit one long beep confirming the
or .
If combinations are set without entering any number, the security system is effectively
overridden and the command can be transmitted simply by pressing
first enter a combination.
NORMAL USE
TABLE C NORMAL USE FOR ACTIVATION OF CHANNEL 1
1 • Type in the combination associated with channel 1;
2 • Press .
Table D normal use for activation of channel 2
1 • Type in the combination associated with channel 2;
2 • Press .
RESET THE UNIT TO FACTORY SETTINGS
To reset the keyboard, it must be sent to our technical services.
without having to
or