Craftsman 320.48298 Manual De Instrucciones página 15

Save and recall measurements
This laser measuring tool automati-
cally saves the last 10 measure-
ments or calculations, as described
below. If more than 10 measure-
ments are made, the new data will
cover the preceding data.
Only single distance, area, volume,
and the calculated third length of a
right triangle data are saved in the
memory. The length and width of the
area; the length, width, and height
of the volume; the measured side
length of a right triangle and the hy-
potenuse length cannot be recalled.
Neither can the calculated sum of
lengths, areas, or volumes be saved
and recalled.
To recall the measurements, press
the side key "RCL": the last ten mea-
surements will be displayed on the
screen (Fig. 22).
1.
1
u
Press the + key to scroll
upwards (Fig. 23).
Press the - key to scroll
downwards (Fig. 24).
Press any other key except
ONiOFF/CLR, Ft/M key to go
back to the preceding mea-
surement mode.
Clear the current measurement
Fig. 22
RCL
÷
f
1
05/05
17.755 ft 2
57.672 ft 3
13.714 ft
Fig. 23
RCL 04/05
÷
f
7.540 ft
17.755 ft
57.672 ft '
Fig. 24
RCL
÷
01!05
57.627 ft 3
13.714 ft
10.640 ft
_-- 03f05
_- 04t05
_- 05!05
4-. 02f05
03105
• @-04fe5
04t05
'4- 05t05
_-- 01/05
1.
2.
In SINGLE-DISTANCE measuring mode: when taking a measurement, press the
CLR key to eliminate the current measuring data. Older measuring data cannot
be cleared. The cleared measuring data will not be saved in the memory; you
cannot recall it later.
In AREA measuring mode, clear the current measured length by pressing the
CLR key; the width and the calculated area cannot be cleared. If the width
measurement is incorrect, you can re-measure the length and width to get
the correct area.
3_
In VOLUME measuring mode, clear the length, the height or both of them by
pressing the CLR key after measuring them. The width and the calculated
volume cannot be cleared. If the width measurement is incorrect, you can
re-measure the length, height and width to get the correct volume.
48298 ManuaLRevised 07-0225 Page 15