Publicidad
Idiomas disponibles
Idiomas disponibles
Original accessories/auxiliary
equipment
Use only accessories and auxiliary equipment
specified in the operating instructions and which
are compatible with the appliance.
WARNING!
■
Do not use any accessories which are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
ATTENTION! Hot surface.
There is a risk of burns.
Before use
Installation on a wall
WARNING!
■
Before wall mounting, make sure that there is
no damage to any cables in the vicinity of the
drill holes required for the mounting.
■
Route the mains cable so that it does not
obstruct you and no one can pull on it acci-
dentally.
■
Do not allow children to play with the appli-
ance, even when it is mounted on the wall.
■
Never operate the charger on a combustible
surface.
■
Never place the charger on a damp surface.
■
Mounting the charger behind doors or within
their swinging range is not recommended, as
there is a risk of it being torn off or otherwise
damaged.
The charger has two holes on the back for wall
installation. You can hang it on a wall, taking the
safety instructions into account. To do this, use two
screws (not supplied) with the specified dimensions
and spacing (see fig. on the fold-out page).
PASSK 20-Li C3
Charging the battery pack (see fig. A)
CAUTION!
►
Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket. The green
charge control LED
red charge control LED
♦
The green LED
indicates that the charging
process is complete and the battery pack
is ready for use.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Push the battery pack
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also dis-
connect the power plug from the mains power
socket.
to the high-speed
(see Fig. A).
lights up briefly, then the
lights up.
flashes, this means
has overheated and
both
back into the appliance.
GB │ IE
│
is
7
■
Publicidad
