Whalen LWSCLICK-09 Instrucciones De Montaje página 4

ASSEMBLY INSTRUCTIONS
7a. Find Drawer Front (8), Drawer back panel (12)and Drawer bottom
panel (13).
7b. Match up "G" label on Drawer bottom panel (13) with "G" label on
Drawer Front (8) ,"H" label on Drawer bottom panel (13) with "H" label
on Drawer back panel (12) and click together. Make sure there are no
gaps between the three panels.
8a. Find Left side drawer panel (10) and Right side drawer panel (11).
8b. Match up "I" label on Drawer bottom panel (13) with "I" label on Left
side drawer panel (10), then match up "J" label on Drawer bottom pan-
el (13) with "J" label on Right side drawer panel (11) and click together.
Make sure there are no gaps between the three panels.
9. Peel and stick four silicone pads (22) onto the inside corners of each
drawer, Then attach the drawer box to the base cabinet.
Note:
1. If you need to remove the drawer, please press the Release Levers on
the mechanisms pre-attached underneath the drawer kit at both ends.
2. If necessary, you can push the Adjustment Clips on the bottom
mechanisms to adjust the top and bottom gaps of the drawer.
Hardware Used
22
Silicone pads
7
H
12
H
G
13
8
Click
8
13
I
I
10
Click
9
22
1
x 4
Release Lever
6
ASSEMBLY INSTRUCTIONS
10. In & Out Adjustment: Turn screw (a) clockwise or counterclockwise.
Up & Down Adjustment: Turn screw (b) clockwise or counterclockwise.
Left & Right Adjustment: Turn screw (c) clockwise or counterclockwise.
Click
G
11a. Insert shelf supports (14) into the desired holes inside each side
compartment. Make sure you place the four shelf supports at the
same level to level the shelf, then put in the adjustable shelf (5).
To remove the shelves, push the tabs on the shelf supports and
Click
lift the shelf.
11
11b. Peel and stick two silicone pads (22) onto the inside corners of
J each door.
J
Hardware Used
14 Shelf Support
22 Silicone pads
Toe Kick Assembly Instructions
NOTE: Toe Kick need to be purchased separately.
12a. Install Front clasp (16) in front of the base cabinet leg, then install the
appropriate length size of the Toe Kick and press down the clasp to
secure the Toe Kick.
12b. Install Side clasp (15) in side of the base cabinet leg, remove the
protective film from 3M adhesive paper on the side clasp, then attach the
appropriate length size of the Toe Kick to the clasp, press to make sure
it sticks firmly.
Hardware Used
15
Side clasp
16
Front clasp
Adjustment Clip
10
b
a
2
11
1
5
x 4
x 4
22
12
15
x 4
x 2
16
7
c
14
Tab