Operating the keypad
Table 3: Quick reference guide
Feature
Description
Arms the system to protect the site perimeter. Movement within the interior does
Arm Home
not trigger an alarm.
Arm Away
Arms the system when you vacate the protected site.
Arms the system without the need to provide a user code.
Quick Arm Home
Note: Enable Quick Arm on the control panel to use this function.
Arms the system without the need to provide a user code.
Quick Arm Away
Note: Enable Quick Arm on the control panel to use this function.
Arms away and enables an automatic latchkey message to one or more
designated phone numbers, or to the user app, when a latchkey user disarms the
Latchkey Arm
system. For example, parents can use this feature to receive a notification when a
child has returned home and disarmed the system. You can assign latchkey users
to users 5 to 8.
Use this feature to skip the entry delay time period after you arm the system.
Instant Arm
A detection in any zone will trigger an immediate alarm.
Disarm
Restores the system to the standby state.
Initiates a silent alarm if you need to disarm the system under duress.
Disarming under
The system disarms normally, but a silent alarm transmits to the monitoring
duress
station.
Emergency alarm
Initiates an emergency alarm.
Fire alarm
Initiates a fire alarm.
Panic alarm
Initiates a panic alarm.
Use the partition feature to arm and disarm up to three controllable areas.
Partitions
Note: Enable partitioning on the control panel to use this feature.
Function button
Activates the function set by the installer. Please refer to Table 2.
6
Command
Press the Arm Home button and enter your user code
or present your tag.
Press the Arm Away button and enter your user code
or present your tag.
Press and hold the Arm Home button for two seconds
Press and hold the Arm Away button for two seconds.
Press the Arm Away button three times.
Press the Arm Home or Arm Away button, enter your
user code or present your tag, and then press the Arm
Instant button.
Press the Disarm button and enter your user code or
present your tag.
Press the Disarm button and enter the duress code.
The default duress code is 2580.
Press and hold the Emergency button for two seconds
Press and hold the Fire button for two seconds.
Press and hold both the Emergency and Fire buttons
for two seconds.
Press Partition buttons 1, 2 or 3 to select a partition
before arming or disarming the system.
Press the Function button.
WK-241 PG2 – Installation Instructions